Clik here to view.
Troubleshooting • Re: Geany 2.0
I built geany 2.1 from github source. I tried a couple of the readme suggestions to get plugins but they failed miserably, but this procedure worked: goto https://download.geany.org/and get...
View ArticleClik here to view.
Interfacing (DSI, CSI, I2C, etc.) • Re: Cannot find the way to extract raw...
However, it seems that the Goodix support team no longer responds to inquiries related to touchscreens. They say they don't respond in the community forums to touchscreen inquiries, and you should...
View ArticleTroubleshooting • Re: Autostart file not working at all
I could edit the wayfire.ini, but it only opened a single browser. However, I would like to be able to open two Chromium web browser URLs to full screen on two separate monitors at start-up. Can...
View ArticleTroubleshooting • Bios does not recognize raspberry Pi in g_multi mode
Hi. I would like to configure a Raspberry Pi so that I can boot Windows 11 ToGo from it. To do this, I configured the Raspberry Pi 5 to run in g_multi (because I also want to use the RaspPi as...
View ArticleCamera board • Re: CSI-Camera Streaming Problems
Thanks for your answer and the links. I came across the Arducam-Muxes before, they however don't work for our application since it is using 6 camera sensors. Our approach for switching is similar...
View ArticleBeginners • Re: USB Y-cable
WARNING!!! THIS CAN BREAK THINGS SO BE SURE YOU ARE AWARE OF THE CONSEQUENCES OF WHAT YOUR DOING!run this commandCode: sudo -E rpi-eeprom-config --editchange toCode:...
View ArticleRaspberry Pi OS • Re: Copying from one Pi to another on RealVNC
Thank you for your reply,Yes, all Raspberry Pi's are on my home network accessed by WiFiStatistics: Posted by RDS — Thu Jul 11, 2024 12:39 pm
View ArticleGeneral discussion • Raspbian + Pi-hole
Hi all I am wanting to install Pi-Hole and set it up.; I currently have my desktop with Raspbian or Debian 11. the output of inxi -S shows Code: $ inxi -SSystem: Host: raspberrypi Kernel: 6.1.21-v8+...
View ArticleTroubleshooting • Re: Brand new RPi 4B freezes
I am using an "official" RPi4 power supply. Rebooted yet again and "vcgencmg get_throttled" returns 0x0. Managed to do this twice before the system froze after 2 mins again. It is now taking nearly a...
View ArticleAdvanced users • Re: Best sd card for raspberry pi 3b+ 2024
The SD Specification v9.00 states that A2 cards must meet A1 speeds when CQ+write caching is turned off. That's been the case with my testing - all the A2 cards I've seen exceed A1 with CQ turned off...
View ArticleTroubleshooting • Re: Broken chip, need identify to replace
Thank you for response. It is a 4B w/4gb mem. I have a Pi Zero 2W that has some fried pins. It appears to have the same chip. Was debating on pulling it off there.Statistics: Posted by zerosha — Fri...
View ArticleNetworking and servers • Re: Possible ? Pi5 with 2 unpowered USB3 hubs and 8...
Hi!From my experience the SATA-USB adapters are frequently the bottleneck. Blown away under load or when just sitting around. If you want to do yourself a favour, find some x86 board with sufficient...
View ArticleGeneral discussion • Re: Raspberry pi 0
Yup. I didn't think of that. I'm not used to working with 0 non-W so it went way over my head.I've got a Zero here that boots only about 1 time out of 4. After that it crashes within a week even when...
View ArticleCamera board • libcamera-hello not working
Fresh full install of bookworm and updates on a Pi3 with a Pi cameraThis is what I seeCode: pi@pi-test:~ $ libcamera-hello --list-camerasAvailable cameras-----------------0 : ov5647 [2592x1944 10-bit...
View ArticleCamera board • Re: libcamera-hello not working
Have you read this?viewtopic.php?t=362707Statistics: Posted by rpiMike — Fri Jul 12, 2024 1:04 pm
View ArticleCamera board • Re: Suppot for OV2311
Hello,6by9 .Use v4l2 device for OV2311, everything is OK . Did you try the 2x2binning function?I add the Regs for Binning like this:Code: static const struct regval ov2311_640x480_2x2binning_regs[] =...
View ArticleClik here to view.
Compute Module • Re: Raspberry pi Compute Module 4 booting issue
Thank you so much, Your advice on Raspberry pi Compute Module 4 booting issue was spot on. I followed your instructions, and it worked perfectly. Actually, power was the main problem for not booting....
View ArticleOther projects • Re: Monitor car battery
There is a very simple (two resistor) monitor project at https://stfn.pl/blog/22-pico-battery-level/You will need to tweak the code depending on the accuracy of the resistors and the Pico ADC - note...
View ArticleClik here to view.
General discussion • Re: New Raspberry Pi Products
Maybe in the ideal world Have you heard of the IBM PC?Yes, but relevant ?Many people come on here with power supply problems, 3rd party products not doing what's expected etc etcThe relevance is that...
View ArticleRaspberry Pi OS • Re: Getting the changes in the latest 2024-07-04 release
Could you tell me where did you find this changelog?I like the easy straightforward ones....https://www.raspberrypi.com/software/op ... -os-32-bitClick on "Release notes"(I think the Release notes are...
View Article